Ford Mustang

This equipment recall is for replacement parts that were sold or installed by Ford dealerships between October 2019 and August 2020. This recall is not being conducted under the requirements of the Motor Vehicle Safety Act. Issue: On certain cars, the brake pedal and bracket assembly could fracture if rapid and forceful pressure is applied to the brake pedal, as typically seen during track and competition driving. If this happens, there could be a loss of braking. Note: This equipment recall only affects the following brake pedal and bracket assembly part numbers: FR3Z-2455-AA FR3Z-2455-AB Safety Risk: A loss of brakes can create the risk of a crash. Corrective Actions: Ford will notify its dealers of this recall. While dealers will attempt to contact people who may have purchased a part affected by this recall, if you have had the brake pedal and bracket assembly replaced on your car, you should contact the dealer that sold or installed it to find out if it is affected by this recall. Any part that is affected by this recall will be replaced, free of charge.

Issue: On certain vehicles, an electrical problem with the rearview camera could cause it not to work properly. As a result, the rearview image may be distorted or not display at all. Safety Risk: A rearview camera image that does not display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: Ford will notify owners by mail and instruct you to take your vehicle to a dealer to replace the rearview camera.

Issue: On certain vehicles, there is a problem with the warnings to tell a driver that the transmission is not in Park. When the ignition is turned off, with the driver door closed, the message and chime to warn that the transmission is not in Park are only active for 3 seconds. Instead, the chime should sound for 10 seconds and the message should display for 30 minutes. As a result, a driver could exit the vehicle without realizing that the transmission is not in Park. If this happens, the vehicle could roll away. Safety Risk: Unintended vehicle movement could increase the risk of injury and/or a crash. Corrective Actions: Ford will notify owners by mail and instruct you to take your vehicle to a Ford dealer to reprogram the instrument panel cluster.

Issue: On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, may eventually degrade the propellant contained in the passenger-front airbag. This could cause the airbag to deploy with more force than normal. If the airbag inflator ruptures, fragments could be propelled toward vehicle occupants or cause damage to the airbag assembly, preventing its proper function. Safety Risk: If the vehicle is involved in a crash requiring an airbag deployment, the airbag inflator could rupture and create a risk of injury. Corrective Actions: Owners will be notified by mail and instructed to take their vehicle to a dealer to have the passenger-front airbag inflator replaced. Note: The Canadian climate results in the propellant degrading slowly. This recall is being conducted as a precaution to address future risk. It is expected that all airbag inflators will be replaced before their function would be affected. Additional note: This recall supersedes recalls 2016-347 (Ford Safety Improvement Program 16S26), 2017-024 (Ford Recall 17S01) and 2018-035 (Ford Recall 18S01). Vehicles repaired under the previous recalls do not require repair under this recall.

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Dealers will replace the passenger frontal airbag inflator. Note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected. Additional note: This recall is superseded by recall 2019005 (Ford Recall 19S01). Please see recall 2019005 for more information.

On certain vehicles, the passenger's frontal airbag inflator could be over pressurized during airbag deployment due to a potential airflow impairment in the inflator module, which may cause the inflator to rupture. An inflator rupture during a crash (where deployment is warranted), could prevent proper deployment of the passenger frontal airbag and could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. Correction: Dealers will replace the passenger frontal airbag module.

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, metal fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Depending on the model, dealers will either replace the passenger frontal airbag inflator or airbag assembly. Note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected. Additional note: This recall is superseded by recall 2019005 (Ford Recall 19S01). Please see recall 2019005 for more information.

On certain vehicles, the pawl spring tab in the side door latch could break. This condition typically will prevent the door from latching. In certain situations where the door is able to be closed, the door may be partially latched and could unlatch while driving. This could increase the risk of injury to a vehicle occupant seated next to the door, or result in damage to property. Correction: If a door will not latch, dealers will replace all four door latches with a more robust part. Note: A door that is partially latched can cause the courtesy light to remain on, set a door ajar message in the instrument cluster and sound a door ajar chime to alert the driver that there is a door latch problem.

Certain vehicles equipped with a 6-speed automatic transmission may experience an intermittent loss of the Transmission Output-shaft Speed Sensor (OSS) signal to the Power Control Module. This could potentially cause an unintended downshift into first gear, which depending on vehicle speed at the time of the downshift, may cause the rear tires to slide or lock up until the vehicle slows. This may result in a loss of vehicle control without warning, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will reprogram the Powertrain Control Module with updated software.

On certain vehicles, the driver frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Note: This recall supersedes special service campaign 2015-052. Correction: Depending on the model, dealers will either replace the driver frontal airbag inflator or airbag module. All vehicles having received a replacement inflator as part of a previous special service campaign will have a replacement inflator installed.

Ford of Canada is conducting a voluntary Safety Improvement Program concerning the driver's airbag inflator on certain vehicles equipped with Takata airbags. Ford will replace the driver's inflator on affected vehicles. This action is not being conducted under the requirements of the Motor Vehicle Safety Act. Note: This special service campaign was replaced by recall 2015232. Please see recall 2015232 for more information: Click here for more information

Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection. The passenger safety belt tension sensor may not have been calibrated properly. This could result in a misclassification of the front passenger seat occupant, which could prevent proper passenger airbag deployment during a crash where deployment is warranted, potentially increasing the risk of injury to the front passenger seat occupant. Correction: Dealers will replace affected safety belt buckles. Note: Affected vehicles have been corrected prior to delivery.

On certain Mustang Shelby GT500 vehicles, the label on the driver's side B-pillar may have incorrect rear tires size information. Correction: Dealers will install updated labels.

On certain Mustang SVT vehicles, when operated in severe driving cycles such as frequent drag race type standing start acceleration, the ball joint in the rear suspension knuckle where the lower control arm attaches may be displaced longitudinally out of its installed position. If this occurs, the stress levels in the knuckle casting will increase and the casting may fracture. The corner of the vehicle will then drop and the lower control arm may contact the inside of the wheel, possibly affecting directional control. Correction: Dealers will install a revised rear suspension knuckle assembly with positive retention of the ball joint.

On certain vehicles equipped with manual transmissions, if parked with the parking brake not fully applied and not in first gear, as directed in the Owner Guide, and the self adjustment pawl subsequently skips one or two teeth, the vehicle could move on some grades. This could result in unintended vehicle movement and a vehicle crash without prior warning. Correction: Dealers will modify the parking brake control and install a plate or over-bracket to the control to lock the self adjust mechanism in position following adjustment.